Thoroughly wipe and clean the tank of your motorcycle. Ensure the bottom mounting base protective material is free from any external debris or metal particles as this may scratch the tank whilst in use. If extra protection is wanted you can use a protective cloth between the tank and the bag to prevent

Remove or raise seat of the bike. Choose a secure part of the frame under the seat to thread the mounting strap through. Guide the male end of the buckle through the loop strap and then lead the male strap up the tank and clip into the female clip.

For the next process locate the mounting straps with 2 male clips. Wrap straps around the front frame/ steering posts. Make sure the straps do not come close or interfere with any wires or cables. After all mounting straps are attached make sure that no part of the bag or straps interfere with the steering. If any problems occur readjust the bag accordingly.

Center the Tail Bag in the center of the tail-end section of the motorcycle with the carrying handle facing the rear of bike.

The Tail Bag comes with 3 Mounting Straps: 1 Rear Mounting Strap and 2 Side Loop Straps. Secure the loop side of the Side Loop Straps to a structural part of the bikes frame and then connect the clip to the D-rings on the Tail Bag. After this, secure the Rear Mounting Strap across the tail-end section of the bike and attach the hooks to the D-rings.

After all Mounting Straps are applied, please recheck that the rear and side straps are securely tightened. Readjust if necessary. Please make sure the Tail Bag is positioned away from an interference with the exhaust pipes or any moving parts of the motorcycle.

Place Saddlebags over the fender of the bike and adjust the Velcro straps, on some bikes you will be able to position the Velcro straps under the seat. Make sure the protective pads are against the tail section, Velcro straps may need to be readjusted to the height you want the bags to hang from the seat.

Insert the hard plastic Saddlebagstiffener in the bottom of the bag and secure it with Velcro loops. Thentuck the ends of the stiffener under the inside opening on each side of thebag. Once the stiffener is properly in place it will help hold the shapeof the bags.

The Saddlebags come with 4 MountingStraps/Loop Straps. On each strap, one side has a loop and the other side has aclip that attaches to the D-Rings on the bags. Secure the loop side to astructural part of the bikes frame and then connect the clip to the D-Rings onthe front of the Saddlebags.